> Settings > Configuring the Settings
Configuring the Settings
Setting the ECO Mode
If the ECO mode is set, the output will automatically stop when little to no output is detected for more than 4 hours. This is helpful in case you forget to turn off the output.
When ECO mode is “On”, the LCD display will automatically turn off approximately 30 seconds after the last button operation.
The ECO mode is set to “Off” by default.
The conditions for the output stopping automatically are shown in the table below. Each output stops automatically and independently.
If there is only one type of output, the power that automatically stops is the same as the output power displayed on the LCD display.
|
Types of Output |
Power at which Output Automatically Stops |
|---|---|
|
AC Output |
Approx. 10 W or less |
|
DC Output |
Approx. 10 W or less |
|
USB Output |
Approx. 1 W or less |
-
1Press and hold the [DISPLAY] button
-
If the [DISPLAY] button is pressed for more than 2 seconds, “ECO” will be displayed on the LCD display and the ECO mode will be “On”.
If the [DISPLAY] button is pressed for more than 2 seconds when ECO mode is set, the “ECO” indication will clear and the ECO mode will be “Off”.
Set ECO mode to “Off” when using devices with low power consumption. If ECO mode is “On”, the supply of power may stopped unexpectedly.
The LED light does not turn off automatically even when ECO mode is “On”.